ARM: zynq: Add target for building bootable SPL image for Zynq
Add a build target to generate 'boot.bin' which includes SPL. This is
used by the platforms BootROM to load SPL directly.
This change also conditionally changes what the 'boot.bin' target
generates depending on the SoC. Leaving the behaviour unchanged for the
AT91 targets.
Signed-off-by: Nathan Rossi <nathan@nathanrossi.com>
Signed-off-by: Michal Simek <michal.simek@xilinx.com>
Cc: Tom Rini <trini@konsulko.com>
Cc: Andreas Bießmann <andreas.devel@googlemail.com>
Cc: Heiko Schocher <hs@denx.de>
Reviewed-by: Tom Rini <trini@konsulko.com>
diff --git a/scripts/Makefile.spl b/scripts/Makefile.spl
index 8f690eb..96f414a 100644
--- a/scripts/Makefile.spl
+++ b/scripts/Makefile.spl
@@ -117,6 +117,7 @@
MLO MLO.byteswap: $(obj)/u-boot-spl.bin
$(call if_changed,mkimage)
+ifeq ($(CONFIG_SYS_SOC),"at91")
MKIMAGEFLAGS_boot.bin = -T atmelimage
ifeq ($(CONFIG_SPL_GENERATE_ATMEL_PMECC_HEADER),y)
@@ -127,6 +128,12 @@
boot.bin: $(obj)/u-boot-spl.bin
$(call if_changed,mkimage)
+else
+MKIMAGEFLAGS_boot.bin = -T zynqimage
+
+spl/boot.bin: $(obj)/u-boot-spl-dtb.bin
+ $(call if_changed,mkimage)
+endif
ALL-y += $(obj)/$(SPL_BIN).bin $(obj)/$(SPL_BIN).cfg
@@ -150,6 +157,10 @@
ALL-y += boot.bin
endif
+ifdef CONFIG_ARCH_ZYNQ
+ALL-y += $(obj)/boot.bin
+endif
+
all: $(ALL-y)
quiet_cmd_cat = CAT $@