README: mx28_common: Do not hardcode the SSP port
MX28 can boot from SSP0 or SSP1, so it is better not to hardcode the SSP port
in the instructions.
Signed-off-by: Fabio Estevam <fabio.estevam@freescale.com>
diff --git a/doc/README.mx28_common b/doc/README.mx28_common
index ac82419..bba2440 100644
--- a/doc/README.mx28_common
+++ b/doc/README.mx28_common
@@ -100,9 +100,7 @@
-----------------------------------------------------------
To boot a MX28 based board from SD, set the boot mode DIP switches according
-to i.MX28 manual chapter 12.2.1 (Table 12-2), PORT=SSP0, SD/MMC master on
-SSP0, 3.3V.
-
+to i.MX28 manual chapter 12.2.1 (Table 12-2).
An SD card the i.MX28 CPU can use to boot U-Boot must contain a DOS partition
table, which in turn carries a partition of special type and which contains a