Add support for ECC DDR initialization on MPC83xx.
diff --git a/CHANGELOG b/CHANGELOG
index 81e7cf2..4a26383 100644
--- a/CHANGELOG
+++ b/CHANGELOG
@@ -2,6 +2,8 @@
Changes since U-Boot 1.1.4:
======================================================================
+* Add support for ECC DDR initialization on MPC83xx.
+
* Add DMA support for MPC83xx.
* Add sync in do_reset() routine for MPC83xx after RPR register
diff --git a/cpu/mpc83xx/spd_sdram.c b/cpu/mpc83xx/spd_sdram.c
index 63dcd66..06a7da8 100644
--- a/cpu/mpc83xx/spd_sdram.c
+++ b/cpu/mpc83xx/spd_sdram.c
@@ -63,12 +63,16 @@
return clks;
}
-unsigned int
-banksize(unsigned char row_dens)
+unsigned int banksize(unsigned char row_dens)
{
return ((row_dens >> 2) | ((row_dens & 3) << 6)) << 24;
}
+int read_spd(uint addr)
+{
+ return ((int) addr);
+}
+
long int spd_sdram(int(read_spd)(uint addr))
{
volatile immap_t *immap = (immap_t *)CFG_IMMRBAR;
@@ -84,7 +88,7 @@
#warning Current spd_sdram does not fit its usage... adjust implementation or API...
CFG_READ_SPD(SPD_EEPROM_ADDRESS, 0, 1, (uchar *) & spd, sizeof (spd));
-
+
if (spd.nrows > 2) {
puts("DDR:Only two chip selects are supported on ADS.\n");
return 0;
@@ -282,8 +286,13 @@
*/
#if defined(CONFIG_DDR_ECC)
if (spd.config == 0x02) {
- ddr->err_disable = 0x0000000d;
- ddr->err_sbe = 0x00ff0000;
+ /* disable error detection */
+ ddr->err_disable = ~ECC_ERROR_ENABLE;
+
+ /* set single bit error threshold to maximum value,
+ * reset counter to zero */
+ ddr->err_sbe = (255 << ECC_ERROR_MAN_SBET_SHIFT) |
+ (0 << ECC_ERROR_MAN_SBEC_SHIFT);
}
debug("DDR:err_disable=0x%08x\n", ddr->err_disable);
debug("DDR:err_sbe=0x%08x\n", ddr->err_sbe);
@@ -297,7 +306,8 @@
* CLK_ADJST = 2-MCK/MCK_B, is lauched 1/2 of one SDRAM
* clock cycle after address/command
*/
- ddr->sdram_clk_cntl = 0x82000000;
+ /*ddr->sdram_clk_cntl = 0x82000000;*/
+ ddr->sdram_clk_cntl = (DDR_SDRAM_CLK_CNTL_SS_EN|DDR_SDRAM_CLK_CNTL_CLK_ADJUST_05);
/*
* Figure out the settings for the sdram_cfg register. Build up
@@ -324,7 +334,7 @@
* If the user wanted ECC (enabled via sdram_cfg[2])
*/
if (spd.config == 0x02) {
- tmp |= 0x20000000;
+ tmp |= SDRAM_CFG_ECC_EN;
}
#endif
@@ -348,29 +358,87 @@
#if defined(CONFIG_DDR_ECC)
/*
+ * Use timebase counter, get_timer() is not availabe
+ * at this point of initialization yet.
+ */
+static __inline__ unsigned long get_tbms (void)
+{
+ unsigned long tbl;
+ unsigned long tbu1, tbu2;
+ unsigned long ms;
+ unsigned long long tmp;
+
+ ulong tbclk = get_tbclk();
+
+ /* get the timebase ticks */
+ do {
+ asm volatile ("mftbu %0":"=r" (tbu1):);
+ asm volatile ("mftb %0":"=r" (tbl):);
+ asm volatile ("mftbu %0":"=r" (tbu2):);
+ } while (tbu1 != tbu2);
+
+ /* convert ticks to ms */
+ tmp = (unsigned long long)(tbu1);
+ tmp = (tmp << 32);
+ tmp += (unsigned long long)(tbl);
+ ms = tmp/(tbclk/1000);
+
+ return ms;
+}
+
+/*
* Initialize all of memory for ECC, then enable errors.
*/
-
-void
-ddr_enable_ecc(unsigned int dram_size)
+//#define CONFIG_DDR_ECC_INIT_VIA_DMA
+void ddr_enable_ecc(unsigned int dram_size)
{
-#ifndef FIXME
- uint *p = 0;
- uint i = 0;
+ uint *p;
volatile immap_t *immap = (immap_t *)CFG_IMMRBAR;
- volatile ccsr_ddr_t *ddr= &immap->im_ddr;
+ volatile ddr8349_t *ddr = &immap->ddr;
+ unsigned long t_start, t_end;
+#if defined(CONFIG_DDR_ECC_INIT_VIA_DMA)
+ uint i;
+#endif
+ debug("Initialize a Cachline in DRAM\n");
+ icache_enable();
+
+#if defined(CONFIG_DDR_ECC_INIT_VIA_DMA)
+ /* Initialise DMA for direct Transfers */
dma_init();
+#endif
- for (*p = 0; p < (uint *)(8 * 1024); p++) {
+ t_start = get_tbms();
+
+#if !defined(CONFIG_DDR_ECC_INIT_VIA_DMA)
+ debug("DDR init: Cache flush method\n");
+ for (p = 0; p < (uint *)(dram_size); p++) {
if (((unsigned int)p & 0x1f) == 0) {
ppcDcbz((unsigned long) p);
}
+
+ /* write pattern to cache and flush */
*p = (unsigned int)0xdeadbeef;
+
if (((unsigned int)p & 0x1c) == 0x1c) {
ppcDcbf((unsigned long) p);
}
}
+#else
+ printf("DDR init: DMA method\n");
+ for (p = 0; p < (uint *)(8 * 1024); p++) {
+ /* zero one data cache line */
+ if (((unsigned int)p & 0x1f) == 0) {
+ ppcDcbz((unsigned long)p);
+ }
+
+ /* write pattern to it and flush */
+ *p = (unsigned int)0xdeadbeef;
+
+ if (((unsigned int)p & 0x1c) == 0x1c) {
+ ppcDcbf((unsigned long)p);
+ }
+ }
/* 8K */
dma_xfer((uint *)0x2000, 0x2000, (uint *)0);
@@ -396,13 +464,31 @@
for (i = 1; i < dram_size / 0x800000; i++) {
dma_xfer((uint *)(0x800000*i), 0x800000, (uint *)0);
}
-
- /*
- * Enable errors for ECC.
- */
- ddr->err_disable = 0x00000000;
- asm("sync;isync");
#endif
-}
+ t_end = get_tbms();
+ icache_disable();
+
+ debug("\nREADY!!\n");
+ debug("ddr init duration: %ld ms\n", t_end - t_start);
+
+ /* Clear All ECC Errors */
+ if ((ddr->err_detect & ECC_ERROR_DETECT_MME) == ECC_ERROR_DETECT_MME)
+ ddr->err_detect |= ECC_ERROR_DETECT_MME;
+ if ((ddr->err_detect & ECC_ERROR_DETECT_MBE) == ECC_ERROR_DETECT_MBE)
+ ddr->err_detect |= ECC_ERROR_DETECT_MBE;
+ if ((ddr->err_detect & ECC_ERROR_DETECT_SBE) == ECC_ERROR_DETECT_SBE)
+ ddr->err_detect |= ECC_ERROR_DETECT_SBE;
+ if ((ddr->err_detect & ECC_ERROR_DETECT_MSE) == ECC_ERROR_DETECT_MSE)
+ ddr->err_detect |= ECC_ERROR_DETECT_MSE;
+
+ /* Disable ECC-Interrupts */
+ ddr->err_int_en &= ECC_ERR_INT_DISABLE;
+
+ /* Enable errors for ECC */
+ ddr->err_disable &= ECC_ERROR_ENABLE;
+
+ __asm__ __volatile__ ("sync");
+ __asm__ __volatile__ ("isync");
+}
#endif /* CONFIG_DDR_ECC */