spl: Change PAD_TO to CONFIG_SPL_PAD_TO
This was already used by some SPL targets, and allows the pad amount to
be specified by board config headers rather than only in makefile
fragments.
Also supply a pad-to of zero if the variable is undefined. It works
without this, but this avoids relying on undocumented behavior.
Signed-off-by: Scott Wood <scottwood@freescale.com>
Signed-off-by: Kim Phillips <kim.phillips@freescale.com>
diff --git a/Makefile b/Makefile
index 9d43499..7e16da9 100644
--- a/Makefile
+++ b/Makefile
@@ -485,8 +485,12 @@
$(obj)u-boot.dis: $(obj)u-boot
$(OBJDUMP) -d $< > $@
+
+
$(obj)u-boot-with-spl.bin: $(obj)spl/u-boot-spl.bin $(obj)u-boot.bin
- $(OBJCOPY) ${OBJCFLAGS} --pad-to=$(PAD_TO) -O binary $(obj)spl/u-boot-spl $(obj)spl/u-boot-spl-pad.bin
+ $(OBJCOPY) ${OBJCFLAGS} --pad-to=$(or $(CONFIG_SPL_PAD_TO),0) \
+ -O binary $(obj)spl/u-boot-spl \
+ $(obj)spl/u-boot-spl-pad.bin
cat $(obj)spl/u-boot-spl-pad.bin $(obj)u-boot.bin > $@
rm $(obj)spl/u-boot-spl-pad.bin
diff --git a/README b/README
index b5c1c03..5105e64 100644
--- a/README
+++ b/README
@@ -2836,6 +2836,10 @@
CONFIG_SPL_LIBGENERIC_SUPPORT
Support for lib/libgeneric.o in SPL binary
+ CONFIG_SPL_PAD_TO
+ Linker address to which the SPL should be padded before
+ appending the SPL payload.
+
CONFIG_SPL_TARGET
Final target image containing SPL and payload. Some SPLs
use an arch-specific makefile fragment instead, for
diff --git a/board/ait/cam_enc_4xx/config.mk b/board/ait/cam_enc_4xx/config.mk
index 744b927..c280029 100644
--- a/board/ait/cam_enc_4xx/config.mk
+++ b/board/ait/cam_enc_4xx/config.mk
@@ -8,7 +8,7 @@
#
#Provide at least 16MB spacing between us and the Linux Kernel image
-PAD_TO := 12320
+CONFIG_SPL_PAD_TO := 12320
UBL_CONFIG = $(SRCTREE)/board/$(BOARDDIR)/ublimage.cfg
ifndef CONFIG_SPL_BUILD
ALL-y += $(obj)u-boot.ubl