kmeter1_nand: allow uasge of NAND_ECC_SOFT_BCH
If CONFIG_NAND_ECC_BCH is set we use 4-bit error corretion code
instead of the 1-bit error correction code on the NAND device
within this driver.
Signed-off-by: Holger Brunck <holger.brunck@keymile.com>
Acked-by: Scott Wood <scottwood@freescale.com>
diff --git a/drivers/mtd/nand/kmeter1_nand.c b/drivers/mtd/nand/kmeter1_nand.c
index e8e5b7b..f044597 100644
--- a/drivers/mtd/nand/kmeter1_nand.c
+++ b/drivers/mtd/nand/kmeter1_nand.c
@@ -119,7 +119,11 @@
int board_nand_init(struct nand_chip *nand)
{
+#if defined(CONFIG_NAND_ECC_BCH)
+ nand->ecc.mode = NAND_ECC_SOFT_BCH;
+#else
nand->ecc.mode = NAND_ECC_SOFT;
+#endif
/* Reference hardware control function */
nand->cmd_ctrl = kpn_nand_hwcontrol;