fdt: ARM: Add fdtcontroladdr to set device tree address in environment
This adds support for a new environment variable called 'fdtcontroladdr'. If
defined, the hex address is used as the address of the control fdt for U-Boot.
Note: I have not changed CONFIG_PRAM section as I already have an
outstanding patch on that.
Signed-off-by: Simon Glass <sjg@chromium.org>
diff --git a/doc/README.fdt-control b/doc/README.fdt-control
index 3f8bb5a..85bda03 100644
--- a/doc/README.fdt-control
+++ b/doc/README.fdt-control
@@ -144,6 +144,18 @@
You cannot use both of these options at the same time.
+If you wish to put the fdt at a different address in memory, you can
+define the "fdtcontroladdr" environment variable. This is the hex
+address of the fdt binary blob, and will override either of the options.
+Be aware that this environment variable is checked prior to relocation,
+when only the compiled-in environment is available. Therefore it is not
+possible to define this variable in the saved SPI/NAND flash
+environment, for example (it will be ignored).
+
+To use this, put something like this in your board header file:
+
+#define CONFIG_EXTRA_ENV_SETTINGS "fdtcontroladdr=10000\0"
+
Limitations
-----------