qcacmn: Add wmi support for btcoex duty cycle command
A new iwpriv command has been added to configure the period
and wlan duration for a btcoex duty cycle.
As a part of this registring the wmi_service_btcoex_duty_cycle
for WMI_SERVICE_BTCOEX_DUTY_CYCLE.
Also send_btcoex_wlan_priority_cmd registrtaion for btcoex
duty cycle command in non_tlv_ops.
Change-Id: I7f3bfdfd9804566d6d0b7cce7025e99db57d0e23
Acked-by: Basamma Yakkanahalli <ybasamma@qti.qualcomm.com>
CRs-Fixed: 1064437
diff --git a/wmi_unified_param.h b/wmi_unified_param.h
index 804756e..e789afe 100644
--- a/wmi_unified_param.h
+++ b/wmi_unified_param.h
@@ -4169,6 +4169,38 @@
uint32_t set;
};
+/* flags bit 0: to configure wlan priority bitmap */
+#define WMI_HOST_BTCOEX_PARAM_FLAGS_WLAN_PRIORITY_BITMAP_BIT (1<<0)
+/* flags bit 1: to configure both period and wlan duration */
+#define WMI_HOST_BTCOEX_PARAM_FLAGS_DUTY_CYCLE_BIT (1<<1)
+struct btcoex_cfg_params {
+ /* WLAN priority bitmask for different frame types */
+ uint32_t btcoex_wlan_priority_bitmap;
+ /* This command is used to configure different btcoex params
+ * in different situations.The host sets the appropriate bit(s)
+ * in btcoex_param_flags to indicate which configuration parameters
+ * are valid within a particular BT coex config message, so that one
+ * BT configuration parameter can be configured without affecting
+ * other BT configuration parameters.E.g. if the host wants to
+ * configure only btcoex_wlan_priority_bitmap it sets only
+ * WMI_BTCOEX_PARAM_FLAGS_WLAN_PRIORITY_BITMAP_BIT in
+ * btcoex_param_flags so that firmware will not overwrite
+ * other params with default value passed in the command.
+ * Host can also set multiple bits in btcoex_param_flags
+ * to configure more than one param in single message.
+ */
+ uint32_t btcoex_param_flags;
+ /* period denotes the total time in milliseconds which WLAN and BT share
+ * configured percentage for transmission and reception.
+ */
+ uint32_t period;
+ /* wlan duration is the time in milliseconds given for wlan
+ * in above period.
+ */
+ uint32_t wlan_duration;
+};
+
+
#define WMI_HOST_RTT_REPORT_CFR 0
#define WMI_HOST_RTT_NO_REPORT_CFR 1
#define WMI_HOST_RTT_AGGREGATE_REPORT_NON_CFR 2
@@ -5228,6 +5260,7 @@
wmi_service_tx_mode_push_pull,
wmi_service_tx_mode_dynamic,
wmi_service_check_cal_version,
+ wmi_service_btcoex_duty_cycle,
wmi_services_max,
} wmi_conv_service_ids;