blob: c68f7ca391ff2d133ce57e1c7c8458f81714a559 [file] [log] [blame]
/*
* Copyright (c) 2011-2016 Cisco and/or its affiliates.
* Licensed under the Apache License, Version 2.0 (the "License");
* you may not use this file except in compliance with the License.
* You may obtain a copy of the License at:
*
* http://www.apache.org/licenses/LICENSE-2.0
*
* Unless required by applicable law or agreed to in writing, software
* distributed under the License is distributed on an "AS IS" BASIS,
* WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
* See the License for the specific language governing permissions and
* limitations under the License.
*/
#ifndef __included_cdp_protocol_h__
#define __included_cdp_protocol_h__
#include <vnet/ethernet/ethernet.h> /* for ethernet_header_t */
#include <vnet/llc/llc.h>
#include <vnet/snap/snap.h>
#include <vnet/srp/packet.h>
typedef CLIB_PACKED (struct
{
u8 version;
u8 ttl;
u16 checksum; /* 1's complement of the 1's complement sum */
u8 data[0];
}) cdp_hdr_t;
typedef struct
{
u8 dst_address[6];
u8 src_address[6];
u16 len;
} ethernet_802_3_header_t;
typedef CLIB_PACKED (struct
{
ethernet_802_3_header_t ethernet;
llc_header_t llc; snap_header_t snap; cdp_hdr_t cdp;
}) ethernet_llc_snap_and_cdp_header_t;
typedef CLIB_PACKED (struct
{
hdlc_header_t hdlc; cdp_hdr_t cdp;
}) hdlc_and_cdp_header_t;
typedef CLIB_PACKED (struct
{
srp_header_t srp;
ethernet_header_t ethernet; cdp_hdr_t cdp;
}) srp_and_cdp_header_t;
typedef CLIB_PACKED (struct
{
u16 t;
u16 l;
u8 v[0];
}) cdp_tlv_t;
/*
* TLV codes.
*/
#define foreach_cdp_tlv_type \
_(unused) \
_(device_name) /* uniquely identifies the device */ \
_(address) /* list of addresses this device has */ \
_(port_id) /* port CDP packet was sent out on */ \
_(capabilities) /* funct. capabilities of the device */ \
_(version) /* version */ \
_(platform) /* hardware platform of this device */ \
_(ipprefix) /* An IP network prefix */ \
_(hello) /* Pprotocol piggyback hello msg */ \
_(vtp_domain) /* VTP management domain */ \
_(native_vlan) /* Native VLAN number */ \
_(duplex) /* The interface duplex mode */ \
_(appl_vlan) /* Appliance VLAN-ID TLV */ \
_(trigger) /* For sending trigger TLV msgs. */ \
_(power) /* Power consumption of that device */ \
_(mtu) /* MTU defined for sending intf. */ \
_(trust) /* Extended trust TLV */ \
_(cos) /* COS for Untrusted Port TLV */ \
_(sysname) /* System name (FQDN of device) */ \
_(sysobject) /* OID of sysObjectID MIB object */ \
_(mgmt_addr) /* SNMP manageable addrs. of device */ \
_(physical_loc) /* Physical Location of the device */ \
_(mgmt_addr2) /* External Port-ID */ \
_(power_requested) \
_(power_available) \
_(port_unidirectional) \
_(unknown_28) \
_(energywise) \
_(unknown_30) \
_(spare_poe)
typedef enum
{
#define _(t) CDP_TLV_##t,
foreach_cdp_tlv_type
#undef _
} cdp_tlv_code_t;
/*
The address TLV looks as follows:
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Number of addresses |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| IDRP encoded address |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
An address is encoded in IDRP format:
0 1 2 3
0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1 2 3 4 5 6 7 8 9 0 1
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| PT | PT Length | Protocol (variable) ...
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Address length | Address (variable) ...
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
PT: Protocol type
1 = NLPID format
2 = 802.2 format
PT Length:
Length of protocol field, 1 for PT = 1, and either 3 or 8 for
802.2 format depending if SNAP is used for PT = 2.
The encodings for the other protocols have the following format:
field: <SSAP><DSAP><CTRL><-------OUI------><protocl_TYPE>
| | | | | | | | |
bytes: 0 1 2 3 4 5 6 7 8
where the first 3 bytes are 0xAAAA03 for SNAP encoded addresses.
The OUI is 000000 for ethernet and <protocl_TYPE>
is the assigned Ethernet type code for the particular protocol.
e.g. for DECnet the encoding is AAAA03 000000 6003.
for IPv6 the encoding is AAAA03 000000 86DD
*/
/*
* Capabilities.
*/
#define CDP_ROUTER_DEVICE 0x0001
#define CDP_TB_DEVICE 0x0002
#define CDP_SRB_DEVICE 0x0004
#define CDP_SWITCH_DEVICE 0x0008
#define CDP_HOST_DEVICE 0x0010
#define CDP_IGMP_DEVICE 0x0020
#define CDP_REPEATER_DEVICE 0x0040
/*
The protocol-hello TLV looks as follows:
0 1 2 3
012345678901234567890123456789012345678
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Type | Length |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| OUI |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| Protocol ID |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
| up to 27 bytes of message |
+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+-+
*/
/*
* These macros define the valid values for the Duplex TLV.
*/
#define CDP_DUPLEX_TLV_HALF 0x0
#define CDP_DUPLEX_TLV_FULL 0x1
#endif /* __included_cdp_protocol_h__ */
/*
* fd.io coding-style-patch-verification: ON
*
* Local Variables:
* eval: (c-set-style "gnu")
* End:
*/