Turn on debugging in jUnit test
Turn on debug level tracing in LCM jUnit testing to test branches
only executed when trace level >= DEBUG.
Change-Id: I2aae7f058461404d6582dc36c72a4f7834692e94
Issue-ID: CCSDK-1096
Signed-off-by: Timoney, Dan (dt5972) <dtimoney@att.com>
diff --git a/lcm/provider/src/test/resources/simplelogger.properties b/lcm/provider/src/test/resources/simplelogger.properties
new file mode 100644
index 0000000..001dfd4
--- /dev/null
+++ b/lcm/provider/src/test/resources/simplelogger.properties
@@ -0,0 +1,22 @@
+###
+# ============LICENSE_START=======================================================
+# ONAP : CCSDK
+# ================================================================================
+# Copyright (C) 2017 AT&T Intellectual Property. All rights
+# reserved.
+# ================================================================================
+# Licensed under the Apache License, Version 2.0 (the "License");
+# you may not use this file except in compliance with the License.
+# You may obtain a copy of the License at
+#
+# http://www.apache.org/licenses/LICENSE-2.0
+#
+# Unless required by applicable law or agreed to in writing, software
+# distributed under the License is distributed on an "AS IS" BASIS,
+# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+# See the License for the specific language governing permissions and
+# limitations under the License.
+# ============LICENSE_END=========================================================
+###
+
+org.slf4j.simpleLogger.defaultLogLevel=debug