Clamp docker image from nexus3 and refactor
Take clamp docker image from nexus3.onap.org instead of default
+ refactor scripts
Change-Id: I87286c2ff4d56f508675a106692b80a69e8be02b
Signed-off-by: eh552t <eh552t@intl.att.com>
Issue-Id: CLAMP-33
diff --git a/test/csit/scripts/clamp/start_clamp_containers.sh b/test/csit/scripts/clamp/start_clamp_containers.sh
new file mode 100755
index 0000000..143012f
--- /dev/null
+++ b/test/csit/scripts/clamp/start_clamp_containers.sh
@@ -0,0 +1,50 @@
+#!/bin/bash
+#
+# ============LICENSE_START=======================================================
+# ONAP CLAMP
+# ================================================================================
+# Copyright (C) 2017 AT&T Intellectual Property. All rights
+# reserved.
+# ================================================================================
+# Licensed under the Apache License, Version 2.0 (the "License");
+# you may not use this file except in compliance with the License.
+# You may obtain a copy of the License at
+#
+# http://www.apache.org/licenses/LICENSE-2.0
+#
+# Unless required by applicable law or agreed to in writing, software
+# distributed under the License is distributed on an "AS IS" BASIS,
+# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+# See the License for the specific language governing permissions and
+# limitations under the License.
+# ============LICENSE_END============================================
+# ===================================================================
+# ECOMP is a trademark and service mark of AT&T Intellectual Property.
+#
+
+echo "This is ${WORKSPACE}/test/csit/scripts/clamp/start_clamp_containers.sh"
+
+# start Clamp and MariaDB containers with docker compose and configuration from clamp/extra/docker/clamp/docker-compose.yml
+docker-compose up -d
+
+# WAIT 5 minutes maximum and test every 5 seconds if Clamp up using HealthCheck API
+TIME_OUT=300
+INTERVAL=5
+TIME=0
+while [ "$TIME" -lt "$TIME_OUT" ]; do
+ response=$(curl --write-out '%{http_code}' --silent --output /dev/null http://localhost:8080/restservices/clds/v1/clds/healthcheck); echo $response
+
+ if [ "$response" == "200" ]; then
+ echo Clamp and its database well started in $TIME seconds
+ break;
+ fi
+
+ echo Sleep: $INTERVAL seconds before testing if Clamp is up. Total wait time up now is: $TIME seconds. Timeout is: $TIME_OUT seconds
+ sleep $INTERVAL
+ TIME=$(($TIME+$INTERVAL))
+done
+
+if [ "$TIME" -ge "$TIME_OUT" ]; then
+ echo TIME OUT: Docker containers not started in $TIME_OUT seconds... Could cause problems for tests...
+fi
+