kubernetes/appc/resources/config/log/filebeat/filebeat.yml

# Copyright © 2018  AT&T, Amdocs, Bell Canada Intellectual Property.  All rights reserved.
#
# Licensed under the Apache License, Version 2.0 (the "License");
# you may not use this file except in compliance with the License.
# You may obtain a copy of the License at
#
#       http://www.apache.org/licenses/LICENSE-2.0
#
# Unless required by applicable law or agreed to in writing, software
# distributed under the License is distributed on an "AS IS" BASIS,
# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
# See the License for the specific language governing permissions and
# limitations under the License.

filebeat.prospectors:
#it is mandatory, in our case it's log
- input_type: log
  #This is the canolical path as mentioned in logback.xml, *.* means it will monitor all files in the directory.
  paths:
    - /var/log/onap/*/*/*/*.log
    - /var/log/onap/*/*/*.log
    - /var/log/onap/*/*.log

  # The below commented properties are for time-based rolling policy. But as the log4j 1.2x does not support time-based rolling these properties are not set
  #Files older than this should be ignored.In our case it will be 48 hours i.e. 2 days. It is a helping flag for clean_inactive
  #ignore_older: 48h
  # Remove the registry entry for a file that is more than the specified time. In our case it will be 96 hours, i.e. 4 days. It will help to keep registry records with in limit
  #clean_inactive: 96h

  #Multiline properties for log4j xml log events
  multiline.pattern: '</log4j:event>'
  multiline.negate: true
  multiline.match: before
  #multiline.max_lines: 500
  #multiline.timeout: 5s

# Name of the registry file. If a relative path is used, it is considered relative to the
# data path. Else full qualified file name.
#filebeat.registry_file: ${path.data}/registry


output.logstash:
  #List of logstash server ip addresses with port number.
  #But, in our case, this will be the loadbalancer IP address.
  #For the below property to work the loadbalancer or logstash should expose 5044 port to listen the filebeat events or port in the property should be changed appropriately.
  hosts: ["{{.Values.config.logstashServiceName}}.{{.Release.Namespace}}:{{.Values.config.logstashPort}}"]
  #If enable will do load balancing among availabe Logstash, automatically.
  loadbalance: true

  #The list of root certificates for server verifications.
  #If certificate_authorities is empty or not set, the trusted
  #certificate authorities of the host system are used.
  #ssl.certificate_authorities: $ssl.certificate_authorities

  #The path to the certificate for SSL client authentication. If the certificate is not specified,
  #client authentication is not available.
  #ssl.certificate: $ssl.certificate

  #The client certificate key used for client authentication.
  #ssl.key: $ssl.key

  #The passphrase used to decrypt an encrypted key stored in the configured key file
  #ssl.key_passphrase: $ssl.key_passphrase