Summary

Copyright 2017-2018 AT&T Intellectual Property. All rights reserved. Copyright (C) 2021 Nordix Foundation. This file is licensed under the CREATIVE COMMONS ATTRIBUTION 4.0 INTERNATIONAL LICENSE Full license text at https://creativecommons.org/licenses/by/4.0/legalcode

This source repository contains the ONAP Policy GUI code.

To build it using Maven 3, run: mvn clean install -P docker

Docker image

Maven produces a single docker image containing the policy GUIs. These are exposed on the same port (8080) using different URLs:

• Apex Policy Editor: http://localhost:8080/apex-editor
• PDP Monitoring UI: http://localhost:8080/pdp-monitoring
• CLAMP Designer UI: http://localhost:8080/clamp

Building

You can use the following command to build the policy-gui docker image:

mvn clean install -P docker

Deployment

Currently, the policy-gui docker image can be deployed with minimal configuration. As the clamp backend is required to use the clamp GUI, you can use the CLAMP_REST_URL environment variable to set its location.

By default, CLAMP_REST_URL is set to an invalid address (0.0.0.0), meaning the CLAMP GUI will not work without specifying CLAMP_REST_URL.

If running clamp as part of a docker network, where policy-clamp-backend is the CLAMP backend, then CLAMP_REST_URL should be set to https://policy-clamp-backend:8443.

If running clamp backend on localhost port 8443, the policy-gui docker image would be started like this:

docker run -p 8080:8080 \
    --add-host host.docker.internal:host-gateway \
    --env CLAMP_REST_URL=https://host.docker.internal:8443 \
    onap/policy-gui