diff --git a/dnsmasq.conf.example b/dnsmasq.conf.example
index 590f217..790eaf5 100644
--- a/dnsmasq.conf.example
+++ b/dnsmasq.conf.example
@@ -189,7 +189,7 @@
 # add names to the DNS for the IPv6 address of SLAAC-configured dual-stack 
 # hosts. Use the DHCPv4 lease to derive the name, network segment and 
 # MAC address and assume that the host will also have an
-# IPv6 address calculated using the SLAAC alogrithm.
+# IPv6 address calculated using the SLAAC algorithm.
 #dhcp-range=1234::, ra-names
 
 # Do Router Advertisements, BUT NOT DHCP for this subnet.
@@ -210,7 +210,7 @@
 #dhcp-range=1234::, ra-stateless, ra-names
 
 # Do router advertisements for all subnets where we're doing DHCPv6
-# Unless overriden by ra-stateless, ra-names, et al, the router 
+# Unless overridden by ra-stateless, ra-names, et al, the router 
 # advertisements will have the M and O bits set, so that the clients
 # get addresses and configuration from DHCPv6, and the A bit reset, so the 
 # clients don't use SLAAC addresses.
@@ -251,7 +251,7 @@
 # the IP address 192.168.0.60
 #dhcp-host=id:01:02:02:04,192.168.0.60
 
-# Always give the Infiniband interface with hardware address
+# Always give the InfiniBand interface with hardware address
 # 80:00:00:48:fe:80:00:00:00:00:00:00:f4:52:14:03:00:28:05:81 the
 # ip address 192.168.0.61. The client id is derived from the prefix
 # ff:00:00:00:00:00:02:00:00:02:c9:00 and the last 8 pairs of
@@ -288,7 +288,7 @@
 # Give a fixed IPv6 address and name to client with 
 # DUID 00:01:00:01:16:d2:83:fc:92:d4:19:e2:d8:b2
 # Note the MAC addresses CANNOT be used to identify DHCPv6 clients.
-# Note also the they [] around the IPv6 address are obilgatory.
+# Note also the they [] around the IPv6 address are obligatory.
 #dhcp-host=id:00:01:00:01:16:d2:83:fc:92:d4:19:e2:d8:b2, fred, [1234::5] 
 
 # Ignore any clients which are not specified in dhcp-host lines
@@ -525,7 +525,7 @@
 # (using /etc/hosts) then that name can be specified as the
 # tftp_servername (the third option to dhcp-boot) and in that
 # case dnsmasq resolves this name and returns the resultant IP
-# addresses in round robin fasion. This facility can be used to
+# addresses in round robin fashion. This facility can be used to
 # load balance the tftp load among a set of servers.
 #dhcp-boot=/var/ftpd/pxelinux.0,boothost,tftp_server_name